This is a very simple project to do, but thanks to him I have an oven at home.
The only place I had on the oven was already occupied by a microwave oven.
The top of the oven heat up so much that you can not put your hand
and the bottom is a little warm. So the oven must stand on the top the rack.
Step 1: Components and tools
8 x angle brackets
32 x screws
2 x fibreboards covered
4 x wooden beams
2 mm drill bit
Step 2: Measuring and cutting
At the beginning I measured how much need to cut fibreboard and wooden beams.
Step 3: Drilling and screwing
For easier screwing, at the beginning I drill the holes with a small drill bit.
Step 4: Rack finished
The rack is finished, it's time to put him in the right place.